Industrial Electrical
Automation & Control in Atlanta, GA
Backed by Jairo's degree in Electronic Engineering with a major in Automation & Control, we install instrumentation, wire SCADA networks, and integrate process loops.
What's included
- ✓ Instrumentation install
- ✓ Loop checks & calibration
- ✓ SCADA / industrial network wiring
- ✓ Control narrative review
We pull your permit & coordinate the inspection
Every job that requires it gets a permit pulled under our Georgia Electrical Contractor license #EN219136. We coordinate the county inspector (Fulton, Cobb, DeKalb, Gwinnett, Cherokee, Forsyth, Henry and surrounding counties) and stay onsite until the work is signed off — so your project is documented, insurable, and 100% code-compliant.
- ✓ Permit application & fees handled
- ✓ NEC 2020 + Georgia amendments
- ✓ County inspector scheduling
- ✓ Sign-off documentation for your records
Frequently asked questions
What kind of instrumentation does your team install and wire? +
Pressure transducers, temperature sensors, flow meters, load cells, and proximity switches. We perform loop checks, calibrate instruments to spec, and termination at PLC terminals. Our Electronic Engineering background means we speak sensor language fluently.
How do you handle SCADA wiring in an industrial facility? +
SCADA networks connect field devices to supervisory systems. We run shielded Ethernet or hardwired analog loops, verify signal integrity with a meter, and document every wire for future troubleshooting. Redundancy and failover are planned upfront.
What's a loop check and why is it critical before startup? +
A loop check verifies that every sensor and transmitter is wired correctly and responds to a known input (pressure, temperature, etc.). We check milliamp signals, confirm linearity, and document range. This catches wiring mistakes before production ramps up.
Need automation & control?
Licensed, insured, and local — free written estimates in metro Atlanta.